Welcome to PC set-up onboarding.

This option is only available for Windows PC and users with the Automatic Subscription

Let's do 3 simple steps to get your PC ready:

Step 1: Install FabStation App

1.3 Install and launch the app.

1.4 Accept any pop-ups that ask to use the device camera; these permissions are required for the software to operate.

All good? Let's go to the 2nd step 👇

Step 2: Register your device

So, you installed FabStation App. Perfect! 🎉🎉 Let's register your device (PC) in our system.

2.1 Open the FabStation App.

You will see "Live" tab with blank login fields. Username will populate when the device is registered and synced, so it's expected it to be blank now.

2.2 Go to Settings:

2.3 Note down (virtual) MAC address.

NOTE: MAC address for the computer will be different from MAC in tablet or Hololens since it's a different device.

2.5 Go to "New Hardware" and fill the requested details:

And now let's complete the final step 👉

Step 3: Sync your device with FabStation App

3.1 Go back to FabStation App > Settings page. Click on "Sync Device":

Once synced, go back to the login screen on the app using the arrow < in the top left corner.

3.3 Once data is downloaded, you will be reverted to the login screen. Please click on "LOGIN" again.

After that, you should see the Home screen.

See the Home screen? Perfect, we are almost done with the setup! 💪

Good job! You have completed the set-up part for your PC! 🎉🎉🎉

Since everything is set up, let's assemble the files for the project 👇